← Back to the blog

How many watts for a 40 km time trial: table by target time and CdA

Pacing6 min readBorja Alfaraz

40 km time trial

250 W

The power needed for exactly one hour in a flat 40 km time trial with a CdA of 0.25 m².

Model calculation: 78 kg with the bike, no wind, at sea level and 15 °C. With a CdA of 0.32 it would take 310 W.

Riding a flat 40 km time trial in one hour takes about 250 W with a CdA of 0.25 m². With a higher CdA of 0.32, the same hour takes 310 W, and with a lower one of 0.22, only 224 W. In other words, the answer depends on position as much as on legs. The table below gives the power for each target time and each position, and the rest of the article explains how to use it to set a rider’s goal.

Summary. The time for a flat time trial depends mostly on two numbers: the power the rider can hold and their CdA, and a power model validated on the road links them accurately1. That is why the power needed for a given time means nothing without the position2,3. The other half of the answer is whether the rider can hold that power for the whole event, and how to pace it4.

How many watts by target time and position?

TimeAverageCdA 0.22CdA 0.25CdA 0.28CdA 0.32
50 min48.0 km/h369 W414 W458 W518 W
55 min43.6 km/h284 W317 W351 W396 W
60 min40.0 km/h224 W250 W276 W310 W
65 min36.9 km/h181 W201 W222 W249 W
70 min34.3 km/h149 W165 W182 W203 W
75 min32.0 km/h125 W138 W151 W169 W

Table 1. Average power to cover 40 flat kilometres in each time. Model calculation: 78 kg with the bike, no wind, sea level and 15 °C, flying start.

Two things stand out. First, power rises much faster than speed: going from 60 to 50 minutes, 20 % faster, takes 66 % more watts with the same CdA. Second, position weighs as much as legs: between a CdA of 0.25 and one of 0.32 there are 60 W for the same hour.

How much does the rider’s weight matter?

On the flat, not much. With a CdA of 0.25, one hour takes 244 W with 65 kg of rider and bike, 250 W with 78 kg and 255 W with 90 kg. Eleven watts between the extremes, against the 60 that separate two positions. That is why flat time trials are talked about in watts rather than watts per kilo, although bigger riders usually have a bigger CdA too. On a course with climbs, weight counts again (see weight or aerodynamics by gradient).

What about heat or altitude?

They change air density, and the watts with it. At 30 °C at sea level, the same hour with a CdA of 0.25 takes 239 W instead of 250. At 1,000 metres and 20 °C, 222 W. The table is built for a cool day on the coast, which is the most demanding case. The detail is in air density, altitude and temperature.

How much time is 10 W worth?

Around the hour mark, about 50 seconds. With a CdA of 0.25, 240 W gives 60:55; 250 W, 60:00; 260 W, 59:09; and 270 W, 58:20. It is a useful figure for setting realistic goals: if a rider wants two minutes off their best without changing position, they need about 24 W more, which is a lot for one season. Lowering CdA is often a shorter road (how much, in how much time a lower CdA saves).

How do you use the table to set a rider’s goal?

  1. Find their column by position: if you do not know their CdA, any reading of the table is a guess. It is worth measuring (how to run a CdA test).
  2. Find their sustainable power: what they can hold for the duration of the event, not their best short test. For a 40 km time trial, that is close to an hour of effort.
  3. Cross the two: the resulting time is their reference on the flat with no wind. If the goal they want is two rows higher, you know how many watts or hundredths of CdA are missing.
Coach’s rule. Before promising a time, read the table with the rider’s real CdA. The same power gives an hour with one position and 62 minutes with another.

What changes in the training plan?

If the gap between their current time and the goal is better closed with watts, the pre-race block is threshold work and sustained time near target power, with long intervals in the time-trial position. If it is better closed with position, the work is CdA testing, adapting to the new position and hours in it at race pace. Either way, check that the rider can hold that power in that position for an hour, because one without the other does not deliver the time. The detailed comparison is in power or position before a time trial.

How do you take it into the race?

  • The table is an average, not a plan: with wind or short climbs, power is split by section and is not the same everywhere on the course (see out-and-back time trial in the wind).
  • The start matters little: a few hard seconds to launch the bike, then target power (time trial start: how hard to push).
  • Steady pacing: in events of this length, starting too hard is paid for in the last third4.

Frequently asked questions

How many watts to break the hour over 40 km?

About 250 W with a CdA of 0.25 m², 224 W with 0.22 and 310 W with 0.32, on the flat, with no wind and at sea level.

And to ride 55 minutes?

About 317 W with a CdA of 0.25. With 0.22, 284 W.

Does the table include a standing start?

No: it assumes the rider is already rolling. A standing start costs about 10 seconds on a 40 km time trial at 300 W with a CdA of 0.24, as we worked out in the article on the start.

What if it is windy?

On an out-and-back course, the same time takes more average watts than with no wind, because a headwind takes more time than a tailwind gives back. The table is the starting point; the plan for the day is built with the wind forecast for the start time.

Does the table work for a triathlon bike leg?

For the power required, yes, if the course is flat. For the goal, not entirely: in triathlon you have to run afterwards, and the power target is set with that in mind too.

For a real course, with its profile and wind, the section-by-section plan is in the demo on the Tour time trial.

References

  1. Martin JC, Milliken DL, Cobb JE, McFadden KL, Coggan AR. Validation of a mathematical model for road cycling power. J Appl Biomech. 1998;14(3):276-91. doi:10.1123/jab.14.3.276
  2. Jeukendrup AE, Martin J. Improving cycling performance: how should we spend our time and money. Sports Med. 2001;31(7):559-69. doi:10.2165/00007256-200131070-00009
  3. Atkinson G, Davison R, Jeukendrup A, Passfield L. Science and cycling: current knowledge and future directions for research. J Sports Sci. 2003;21(9):767-87. doi:10.1080/0264041031000102097
  4. Abbiss CR, Laursen PB. Describing and understanding pacing strategies during athletic competition. Sports Med. 2008;38(3):239-52. doi:10.2165/00007256-200838030-00004

Related articles