What power to ride in an Ironman: close to the first threshold and almost constant
Ironman bike
5.4 min
What 10 W more saves over the 180 km of a flat Ironman, for a triathlete riding at 200 W.
Model calculation: 80 kg with the bike, CdA 0.28 m², no wind. Lowering CdA by 0.01 m² saves 3.4 min at the same power.
The right bike power in an Ironman is what the athlete can sustain close to their first threshold, the end of the comfortable zone, for about five hours, while eating and drinking, and arriving at the marathon with legs left. In 21 long-distance triathletes, average bike heart rate was 148 bpm against 146 at their first ventilatory threshold and 160 at the second1. It is not a percentage of FTP: it is a physiological intensity, and the power that matches it is measured athlete by athlete.
How hard do athletes really ride on an Ironman bike leg?
Two studies of long-distance triathletes paint the same picture. In the first, bike heart rate did not differ from that at the first ventilatory threshold and stayed below the second threshold and the deflection point1. In the second, with nine triathletes, bike heart rate stayed below both thresholds measured in the lab2. And the detail that matters most to a coach: the further above the first threshold athletes rode on the bike, the slower their marathon (r = 0.61)1.
This needs careful reading. These are correlations in small groups, measured with heart rate, which rises with heat and hours even when power does not change. But the direction is clear: an Ironman bike leg is a sustained moderate effort, not a long time trial.
Why does power drop over the 180 km?
On a flat three-lap Ironman course of 60 km laps, six well-trained triathletes who finished the bike in 5 h 11 min went from 239 W average on the first lap to 203 W on the last3. Part of that is fatigue and part is starting too eagerly. Thresholds measured fresh are not the same in the fourth hour, and that loss, durability, varies a lot between people5.
That is why the target power for the first hour has to be one the athlete can also hold in the fifth. If power always fades in the second half of long simulations, either the target was too high or nutrition is not sorted, and both can be trained.
How much time does each watt buy over 180 km?
Table 1 shows bike split times over 180 flat km with no wind for two positions. These are model figures, an example with reasonable inputs and not a prediction for a specific course.
| Average power | CdA 0.25 m² | CdA 0.30 m² |
|---|---|---|
| 160 W | 5:18 (34.0 km/h) | 5:36 (32.1 km/h) |
| 180 W | 5:04 (35.6 km/h) | 5:21 (33.6 km/h) |
| 200 W | 4:52 (37.0 km/h) | 5:09 (35.0 km/h) |
| 220 W | 4:42 (38.3 km/h) | 4:58 (36.2 km/h) |
| 240 W | 4:33 (39.6 km/h) | 4:49 (37.4 km/h) |
Table 1. Bike split (h:min) over 180 flat km with no wind. Model example: 80 kg for triathlete and bike, Crr 0.004, air density 1.20 kg/m³.
At 200 W and a CdA of 0.28 m², 10 W more saves about 5.4 minutes, and lowering CdA by 0.01 m² saves 3.4 minutes. Watts cost energy, glycogen and legs for the marathon; CdA costs nothing if the position can be held for five hours. In an Ironman, a sustainable position is worth more than the most aggressive one the athlete can only hold for half an hour (see what CdA is good for triathlon).
Constant or variable with wind and hills?
On the flat with no wind, almost constant: in the example, keeping the same 200 W average while alternating equal stretches of 230 and 170 W costs 54 seconds. With wind or hills, however, it pays to raise power a little where you are slow and lower it where you are fast4. In an out-and-back example of 90 km each way with a 15 km/h wind and the same 200 W average, riding 210 W into the headwind and 184 W with the tailwind saves 91 seconds; 220 and 169 W saves 160 seconds.
In an Ironman that variation has a limit: every surge above target power moves towards the second threshold, and the literature suggests that time spent above the first is paid for on the run1. A margin of 5 to 10% on climbs and into headwinds is reasonable; more only if the athlete has rehearsed it in long sessions.
How do you set target power?
- Measure the first threshold in a lab test and link it to power, not only to heart rate.
- Check it in simulations of four or five hours on the race bike, eating what will be eaten on race day, and watching whether power holds in the second half.
- Review the position: the CdA that counts is the one held for five hours. A position that forces the athlete to sit up every ten minutes costs more than it saves.
- Plan by segments with the course and the wind forecast at time of passage, which changes a lot over five hours. SuperRecord builds that plan and puts it on the Garmin; you can try it in the demo.
How the plan changes with time of day and wind is covered in what changes in the plan with start time, and the middle distance in what power to ride in a 70.3.
What is known and what is not
It is documented that the Ironman bike leg is ridden close to the first threshold and below the second1,2, that power tends to fall over the segment3 and that varying power with wind and gradient saves time4. What remains unresolved is how much each athlete loses over the hours5, and how much their marathon suffers per extra watt. Those two things are measured with the athlete, not taken from a table.
Frequently asked questions
How many watts should you ride in an Ironman?
Whatever the athlete can sustain close to their first threshold for about five hours. In watts that depends on each person; in the article's table, 200 W with a CdA of 0.25 gives about 4 h 52 min over 180 flat km.
Is it the same percentage of FTP as in a 70.3?
No. An Ironman lasts twice as long and is ridden easier. The Ironman reference is the first threshold; the 70.3 sits somewhat above it.
Is it normal for power to drop in the last hour?
It is common, even in well-trained triathletes. If it drops a lot, review starting power and nutrition before blaming fitness.
Is it worth varying power with the wind?
Yes, in moderation. Just 5% more into the headwind saves a minute and a half in the 180 km example, without getting too close to the second threshold.
References
- Laursen PB, Knez WL, Shing CM, Langill RH, Rhodes EC, Jenkins DG. Relationship between laboratory-measured variables and heart rate during an ultra-endurance triathlon. J Sports Sci. 2005;23(10):1111-20. doi:10.1080/02640410400023209
- Barrero A, Chaverri D, Erola P, Iglesias X, Rodríguez FA. Intensity profile during an ultra-endurance triathlon in relation to testing and performance. Int J Sports Med. 2014;35(14):1170-8. doi:10.1055/s-0034-1374601
- Abbiss CR, Quod MJ, Martin DT, Netto KJ, Nosaka K, Lee H, et al. Dynamic pacing strategies during the cycle phase of an Ironman triathlon. Med Sci Sports Exerc. 2006;38(4):726-34. doi:10.1249/01.mss.0000210202.33070.55
- Atkinson G, Peacock O, Passfield L. Variable versus constant power strategies during cycling time-trials: prediction of time savings using an up-to-date mathematical model. J Sports Sci. 2007;25(9):1001-9. doi:10.1080/02640410600944709
- Maunder E, Seiler S, Mildenhall MJ, Kilding AE, Plews DJ. The importance of "durability" in the physiological profiling of endurance athletes. Sports Med. 2021;51(8):1619-28. doi:10.1007/s40279-021-01459-0
Related articles
- PacingHow many watts for a 40 km time trial: table by target time and CdA6 min read
- PacingVariability index in time trials and triathlon: what value is good, and when a low number misleads6 min read
- PacingWhat power to ride on the bike in an Ironman 70.3, and how much time each watt is worth7 min read