← Back to the blog

CdA values in cycling: what CdA is good on the road, in a time trial and in triathlon

Aerodynamics7 min readBorja Alfaraz

CdA values

0.23 m²

Average CdA in the time-trial position across the wind-tunnel studies compiled by Defraeye et al. (2010), with a spread of 0.03.

Rider with bike. On the road and pedalling, measured values are usually higher.

Summary. CdA sums up how much the air slows the rider and bike together, and above about 50 km/h it takes around 90% of power5. This article collects published values by position, measured in the wind tunnel, on the velodrome and on the road1,2,3,4, explains why your number rarely matches a table, and uses a physical model to turn each value into minutes over a 40 km time trial.

As a rough guide, for rider and bike together: on the road with hands on the tops, 0.27 to 0.36 m²; in the drops, 0.24 to 0.31; in the time-trial position, about 0.23 on average in the wind tunnel and 0.26 to 0.36 for amateurs measured on the road. A CdA is "good" when it is low for that position and that rider, and when it can be held for the whole event.

What CdA values have been measured in each position?

PositionCdA (m²)How it was measured
Road, hands on tops0.270 to 0.358Wind tunnel, static [1]
Road, hands in drops0.243 to 0.307Wind tunnel, static [1]
Time trial, several studies0.23 ± 0.03Wind tunnel, mean of studies [1]
Time trial, one rider in tunnel0.211Wind tunnel, static [1]
Time trial, professionals0.237 to 0.240Velodrome and tunnel [4]
Time trial, amateurs on TT bikes0.258 to 0.355Road, racing [2]
Amateurs, all bikes0.349 ± 0.059Road, racing [2]

Table 1. Published CdA values for rider and bike together. The road ranges for tops and drops combine Defraeye et al.'s value with that of Jeukendrup and Martin (2001), which they compile [1]. Numbers in brackets point to the references.

The table is a rough guide for one reason: values are not interchangeable between studies. The rider, the bike, the helmet, the test speed and, above all, whether the rider is static or pedalling all change them. In five professionals on TT bikes, drag while pedalling at race pace was 31% higher than in the same position when static3. That is why static tunnel values are the lowest in the table and road values while racing are the highest.

What is a good CdA on the road?

On a road bike, what matters most is where the hands are and how low the torso goes. In the wind tunnel, moving from the tops to the drops lowered CdA from 0.270 to 0.243 m², and the time-trial position to 0.2111. For a coach, the useful number is not the absolute one but the difference between positions for the same rider: it tells you what riding in the drops is worth on a flat, windy stretch.

And in a time trial?

In professionals measured in time-trial position, CdA was 0.240 m² in the wind tunnel and 0.237 on the velodrome, and small changes to bars and pads lowered it by 0.011 m² on average, 4.6%4. In amateurs who raced a 22 km time trial on TT bikes, road-measured CdA ranged from 0.258 to 0.355 m²2. And today's elite go lower still: the SuperRecord demo reproduces the 2026 Tour time trial with a CdA of 0.176 m².

In that same amateur study, road-measured CdA explained time-trial time better than any single lab variable, and power divided by CdA was the best predictor of all2. That is the most direct argument for measuring it.

And in triathlon?

The sources in this article do not give a specific triathlon value. A triathlon position is a time-trial position adapted to two to five hours and to the run that follows, so the target CdA is the lowest the athlete can hold for the whole bike leg without losing power. As a model example, at 200 W over 90 flat km, going from 0.30 to 0.25 m² cuts the bike split from 2:35 to 2:26, nine minutes without spending an extra watt. We develop this in what power to ride in a 70.3.

How much time is each value worth over 40 km?

CdA (m²)Time at 250 WSpeedWatts to match 0.24
0.2156:4742.3 km/h223 W
0.2459:1440.5 km/h250 W
0.2761:2939.0 km/h277 W
0.3063:3437.8 km/h304 W
0.3566:4635.9 km/h348 W

Table 2. Flat 40 km time trial at 250 W by CdA, and the power needed to go as fast as with 0.24 m². Model example: 78 kg for rider and bike, Crr 0.004, air density 1.225 kg/m³, no wind.

Between an amateur on a TT bike with a CdA of 0.30 m² and another at 0.24 there are more than four minutes over 40 km at the same power. Closing that gap with the legs would take 54 W more. So before asking for more watts, it pays to know where your rider starts from (see power or position before a time trial).

Why does your CdA not look like the table?

  • Size: the body accounts for most of the drag; a bigger rider starts from a higher number.
  • Static or pedalling: leg movement raises drag, by up to 31% in professionals3.
  • Where it is measured: tunnel, velodrome and road give similar values for the same rider if the method is sound4,5, but not across different studies.
  • Equipment and the day: helmet, skinsuit, wheels, crosswind and a poorly estimated air density all move the result.
Rule of thumb. A CdA from a table helps you get your bearings; the one that drives the plan is your rider's, measured on their bike, in their helmet and at race pace.

How do you use the value in practice?

Measure the starting point with a road test (see how to run a CdA test), change one thing at a time and measure again. SuperRecord calculates CdA from the .FIT file of a ride, warns you when the figure is not reliable and uses that CdA in the power plan; you can see it in the demo.

What is known and what is not

There are good reference values for typical positions in the wind tunnel1 and in professionals3,4, and well-run field methods give results comparable to the tunnel5. What is missing is broad tables by level, age or discipline, and in particular published race data from age-group triathletes.

Frequently asked questions

What is a good CdA for a time trial?

For amateurs on TT bikes measured on the road, 0.26 to 0.36 m²; below 0.25 is already a good position, and professionals sit around 0.24 or lower.

What CdA does a road cyclist have?

In the wind tunnel, 0.27 to 0.36 on the tops and 0.24 to 0.31 in the drops, depending on the rider and the study.

How much time do I gain by lowering CdA?

In a flat 40 km time trial at 250 W, going from 0.27 to 0.24 m² saves a little over two minutes according to the model.

Can I compare my CdA with another rider's?

Only with care: size, equipment and method all change the number. It is far more useful to compare your CdA with itself before and after a change.

References

  1. Defraeye T, Blocken B, Koninckx E, Hespel P, Carmeliet J. Aerodynamic study of different cyclist positions: CFD analysis and full-scale wind-tunnel tests. J Biomech. 2010;43(7):1262-8. doi:10.1016/j.jbiomech.2010.01.025
  2. Peterman JE, Lim AC, Ignatz RI, Edwards AG, Byrnes WC. Field-measured drag area is a key correlate of level cycling time trial performance. PeerJ. 2015;3:e1144. doi:10.7717/peerj.1144
  3. García-López J, Rodríguez-Marroyo JA, Juneau CE, Peleteiro J, Martínez AC, Villa JG. Reference values and improvement of aerodynamic drag in professional cyclists. J Sports Sci. 2008;26(3):277-86. doi:10.1080/02640410701501697
  4. García-López J, Ogueta-Alday A, Larrazabal J, Rodríguez-Marroyo JA. The use of velodrome tests to evaluate aerodynamic drag in professional cyclists. Int J Sports Med. 2013;35(5):451-5. doi:10.1055/s-0033-1355352
  5. Debraux P, Grappe F, Manolova AV, Bertucci W. Aerodynamic drag in cycling: methods of assessment. Sports Biomech. 2011;10(3):197-218. doi:10.1080/14763141.2011.592209

Related articles