← Back to the blog

Garmin Power Guide in a time trial: how it works and where it falls short

Time trial7 min readBorja Alfaraz

Garmin Power Guide

2:47

How far the time forecast for a flat 40 km time trial at 300 W moves if the chosen position amounts to a CdA of 0.28 m² and the rider actually has 0.24.

Model example, not a real case: 78 kg with the bike, no wind. We do not know what CdA Garmin assigns to each position; the figure shows how much that input weighs.

Garmin Power Guide is there so a rider without a coach can ride a course with a power target by section instead of a single number. For a time trial where the coach wants a specific time and decides where every watt goes, it falls short: according to its own manual, it starts from FTP and a position picked from a list, and its stated goal is not a target time. This article explains exactly what it does, using what the official manual says and nothing else, and when it is worth going further.

Summary. Varying power with gradient and wind saves time compared with riding constant2,3, as long as the variation is in the right place4. Garmin’s tool applies that idea automatically. The practical question is whether its inputs are good enough for an event raced against the clock, and the answer depends on how much those inputs weigh in a validated power model1.

What does Garmin Power Guide do, according to its manual?

The Edge 840 manual and the Edge 1040 manual describe the feature in almost the same words. In short:

  • Inputs: the rider’s FTP, the course elevation and the projected time to complete it.
  • What you choose when creating it: the course (saved or created on the spot), the riding position and the gear weight.
  • Effort level: a harder effort raises the power recommendations and an easier one lowers them. It can be changed during the ride.
  • What it is for: the manual says its main goal is to help you complete the course based on what is known about your ability, not to hit a specific target time.
  • Limits: it is always tied to a course, cannot be used with workouts or segments, and needs a paired power meter.
  • Where it is edited: it can be viewed and edited in Garmin Connect and synced to compatible devices.

The Edge manual does not explain how it handles wind, so we make no claim about that here. If wind is going to decide the event, check the strategy in Garmin Connect before the start.

Who is it well designed for?

For the sportive rider or triathlete doing a long course who wants to avoid going too hard on the climbs. There the approach makes sense: starting from FTP, which almost everyone already has on their Edge, and turning a single effort dial is easy to understand and use. The idea behind it, more power where you are slow and less where you are fast, is what the literature has supported for decades2,3.

Where does it fall short in a time trial?

In a time trial the coach is not trying to get the rider round the course: the goal is a time, and coach and rider decide how much to vary power and where. Going by the manual, there are four points where that does not fit.

  1. The goal is not the time. The manual says so itself. In a time trial the whole plan exists to lower a time, and the coach’s question is how many watts that takes and whether the rider has them.
  2. Aerodynamics come from a list. The position is chosen from a set of options, not measured. On the flat, air takes most of the power1, and the gap between two riders on the same bike is large. In the example above, going from a CdA of 0.24 to 0.28 moves the forecast for a 40 km time trial at 300 W by 2:47, and riding the same time with 0.28 would take 344 W instead of 300. An input that heavy should be measured, not picked.
  3. Everything hangs on FTP. If the FTP on the Edge is out of date, every target shifts at once. And FTP does not tell you how much reserve the rider has above it, which is what decides how hard they can push on a two-minute ramp without paying for it later.
  4. It belongs to the rider, not the coach. The strategy lives in the rider’s Garmin Connect account. If the coach changes the plan the night before, it has to be done from the rider’s account or by the rider.
In one sentence. Garmin Power Guide spreads a rider’s effort so they finish a course well. A time trial plan spreads a specific rider’s power so they ride a specific time.

How much is good pacing worth in a time trial?

Quite a lot if the course has climbs or wind. In the 2026 Tour time trial in the SuperRecord demo, riding constant power at the same average would have cost 37 seconds against the section plan (explained in how much to vary power in a hilly time trial). But the split only wins if it is well placed: with riders on a simulated time trial, varying power without following the gradient made the time worse, not better4. That is why the inputs matter as much as the idea: a good split built on the wrong CdA or FTP puts the watts in the right place but at the wrong value.

Garmin Power Guide or a coach’s section plan?

AspectGarmin Power GuideCoach’s section plan
GoalComplete the course based on the rider’s abilityA specific time, and whether it is within reach
AerodynamicsPosition picked from a listThe rider’s measured CdA
Physiological starting pointFTP and effort levelWhatever the coach decides, with a ceiling on climbs
Who controls itThe rider, in Garmin ConnectThe coach, who sends it to the Edge
After the raceThe manual describes no review of the planPlanned against actual, section by section

Table 1. Garmin column: only what the Edge 840 and Edge 1040 manuals say. Coach column: what SuperRecord does.

What changes in the training plan?

If the rider is going to use Garmin’s tool, two jobs before the race avoid most problems. The first is an up-to-date FTP on the Edge, because everything hangs on it. The second is to rehearse the course, or a similar one, with the guide running, to see whether the power changes it suggests can be executed at that intensity. The strategies that stray furthest from average power are the hardest to sustain at the end5.

If the coach builds the plan, the pre-race block changes: measure the rider’s CdA in race position (how, in how to run a CdA test with your rider), set a power ceiling for the climbs and rehearse the plan’s transitions in specific intervals.

How do you take it into the race?

  • With Garmin’s guide: choose it under Training, Power Guide, select Ride and start the timer, as the manual describes. Decide beforehand whether the rider will touch the effort level during the race: that call is better made with a cool head.
  • With a coach’s plan: a data field showing the section target and how far ahead or behind the forecast the rider is. That is what the SuperRecord Pacer field does, explained in how to carry your power plan on your Garmin.
  • Either way: a clean screen with few fields. What to put on it is in the Garmin Edge data screen for time trials.

Frequently asked questions

Is Garmin Power Guide any good for a time trial?

It helps avoid overcooking the climbs if there is no other plan. For chasing a specific time it falls short, because its own manual says it is not designed for that.

Can you change the effort during the race?

Yes. The manual says the effort level can be adjusted during the ride.

Does it work with a structured workout?

No. According to the manual it is always tied to a course and cannot be used with workouts or segments.

Does it account for wind?

The Edge manual does not say. If wind is decisive, check the strategy before the race.

You can see a full time trial plan, section by section, in the demo on the Tour time trial.

References

  1. Martin JC, Milliken DL, Cobb JE, McFadden KL, Coggan AR. Validation of a mathematical model for road cycling power. J Appl Biomech. 1998;14(3):276-91. doi:10.1123/jab.14.3.276
  2. Swain DP. A model for optimizing cycling performance by varying power on hills and in wind. Med Sci Sports Exerc. 1997;29(8):1104-8. doi:10.1097/00005768-199708000-00017
  3. Atkinson G, Peacock O, Passfield L. Variable versus constant power strategies during cycling time-trials: prediction of time savings using an up-to-date mathematical model. J Sports Sci. 2007;25(9):1001-9. doi:10.1080/02640410600944709
  4. Wells MS, Marwood S. Effects of power variation on cycle performance during simulated hilly time-trials. Eur J Sport Sci. 2016;16(8):912-8. doi:10.1080/17461391.2016.1156162
  5. Abbiss CR, Laursen PB. Describing and understanding pacing strategies during athletic competition. Sports Med. 2008;38(3):239-52. doi:10.2165/00007256-200838030-00004

Related articles