What percentage of FTP to ride in a time trial, depending on how long it lasts
FTP and duration
88 to 96%
What 60-minute time-trial power amounted to relative to 20-minute power in 120 cyclists: 88% in recreational riders, 96% in professionals.
Sitko et al. (2023). With FTP taken as 95% of 20-minute power, the hour sits between about 93% of FTP in recreational riders and around 100% in professionals.
As a guide: a time trial of about 10 minutes is ridden clearly above FTP; a 20-minute one, about 5% above it if FTP was taken as 95% of 20-minute power; one of 30 to 45 minutes, around FTP, above or below depending on the rider; and a one-hour effort, between about 93% of FTP in recreational riders and around 100% in professionals. Beyond that, below FTP. These are ranges from studies, not a recipe: your rider may fall outside them.
Why is there no fixed percentage?
Because FTP describes an intensity, not a duration. In 23 trained cyclists, the time they could hold their FTP was 50.9 ± 15.7 minutes1: for some, well over an hour; for others, little more than half. In another study, the median was 35 minutes in recreational riders, 42 in trained, 47 in well-trained and 51 in professionals2. The same "100% of FTP" is a well-judged 40 km time trial for one rider and a blow-up at kilometre 25 for another.
On top of that, FTP and critical power agree on average but not for each rider: in 12 competitive cyclists, 278 versus 275 W, with individual differences of up to about 30 W either way4. That gap is exactly what separates a well-paced time trial from one where the rider arrives empty at the end.
What does the literature say for each duration?
| Duration | Example event | Rough reference | Where it comes from |
|---|---|---|---|
| About 10 min | Prologue or 7 km TT | Clearly above FTP | Held thanks to the reserve above critical power [4] |
| About 20 min | 15 km TT | About 5% above FTP | By definition, if FTP is 95% of 20 min [1] |
| About 27 min | 16 to 20 km TT | Between FTP and 20-min power | Critical power and reserve predicted the time [4] |
| 30 to 50 min | 30 km TT | Around FTP, depending on the rider | Medians of 35 to 51 min at FTP [2] |
| About 60 min | 40 km TT | From 93% to around 100% of FTP | 88 to 96% of 20-min power [3] |
| Over 60 min | Long TT, triathlon | Below FTP | FTP is not held that long [1, 2] |
Table 1. Rough intensity by duration. Example distances are for a 250 W rider with CdA 0.24 m² and 78 kg on the flat (physical model): 7 km in 10:22, 15 km in 22:13, 20 km in 29:37, 30 km in 44:26 and 40 km in 59:14. The one-hour percentages assume FTP taken as 95% of 20-minute power.
Note that the table talks about duration, not distance. A 40 km time trial takes 59 minutes for a 250 W rider and a good deal longer for a 200 W rider. The first thing to estimate is how long your rider will take; then, what intensity they can hold for that long.
How does it change with rider level?
Quite a lot. In 120 cyclists, one-hour power was 88% of 20-minute power in recreational riders, 92% in trained, 95% in well-trained and 96% in professionals3. Put another way: the classic 95% works for a well-trained rider and overestimates a recreational rider's hour. The same goes for the time FTP can be held, which grows with level and experience2.
For a coach, the consequence is direct. With a recreational rider, planning a one-hour time trial at 100% of FTP means asking for more than most of their group can sustain. With a professional, the same percentage may be too cautious.
How should that power be distributed within the time trial?
In time trials longer than about 10 minutes and in stable conditions, an almost even distribution is most effective; in shorter ones it pays to push a little harder at the start, and on the road, to raise power on climbs and into headwinds5. The error that shows up most in studies is the opposite one: even experienced riders start above the optimum5. We put numbers on it in how hard to push at the start of a time trial.
How do you set the target in practice?
- Estimate the duration from the course, CdA and weather, not from the distance.
- Look for similar efforts in the rider's history: best 20, 30 or 60-minute power says more than an FTP test from months ago.
- Adjust for level: with recreational riders, more caution in one-hour time trials3.
- Distribute by segments: a correct average badly distributed gives a bad time. SuperRecord distributes power by segment according to course, wind and the rider's reserve; you can see it in the demo. For climbs, see what power ceiling to set on each climb.
What is known and what is not
It is well measured that the time FTP can be held varies widely between people and grows with level1,2, that the relationship between 20 and 60-minute power depends on level3 and that the critical power model predicts time trials of just under half an hour well4. What is missing are studies directly measuring the percentage of FTP in real 10 and 40 km time trials across rider levels. Until then, the rider's own history is the most reliable guide.
Frequently asked questions
What percentage of FTP is a 40 km time trial?
If it lasts an hour, between about 93% of FTP in recreational riders and around 100% in professionals, based on the measured relationship between 20 and 60-minute power. If it is shorter, a bit more.
And a 20-minute time trial?
About 5% above FTP, if FTP was taken as 95% of the power from a 20-minute test.
Can FTP be held for an hour?
Only by some riders. On average it is held for about 51 minutes, with wide variation. This AthletePro article covers it in depth.
Which is better for setting the target, FTP or critical power?
They agree on average but can differ by about 30 W in a given rider. The best approach is to check both against real efforts of the same duration as the time trial.
References
- Borszcz FK, Tramontin AF, Bossi AH, Carminatti LJ, Costa VP. Functional threshold power in cyclists: validity of the concept and physiological responses. Int J Sports Med. 2018;39(10):737-42. doi:10.1055/s-0044-101546
- Sitko S, Cirer-Sastre R, López-Laval I. Time to exhaustion at estimated functional threshold power in road cyclists of different performance levels. J Sci Med Sport. 2022;25(9):783-6. doi:10.1016/j.jsams.2022.06.007
- Sitko S, Cirer-Sastre R, López-Laval I. An update of the Allen & Coggan equation to predict 60-min power output in cyclists of different performance levels. Int J Sports Med. 2023;44(13):983-7. doi:10.1055/a-2079-1363
- Morgan PT, Black MI, Bailey SJ, Jones AM, Vanhatalo A. Road cycle TT performance: relationship to the power-duration model and association with FTP. J Sports Sci. 2019;37(8):902-10. doi:10.1080/02640414.2018.1535772
- Atkinson G, Peacock O, St Clair Gibson A, Tucker R. Distribution of power output during cycling: impact and mechanisms. Sports Med. 2007;37(8):647-67. doi:10.2165/00007256-200737080-00001
Related articles
- Time trialGarmin Power Guide in a time trial: how it works and where it falls short7 min read
- Time trialHow to analyse a time trial with power after the race: what to look at and how to explain it to your rider7 min read
- Time trialGarmin Edge data screen for time trials and triathlon: which fields to show and which to drop6 min read