← Back to the blog

What power ceiling should my rider hold on each climb?

PacingUpdated 6 min readBorja Alfaraz

Example ceiling

333 W

Ceiling for an 8-minute climb for a rider with a 300 W CP and a 20 kJ W′, cresting with 4 kJ in reserve.

At 360 W the same reserve is gone after 5 min 33 s. An example calculated with the critical power model, not a real case.

The rider who blows up on the last climb rarely does so for lack of form. They do it because nobody told them their ceiling, or because the ceiling was set for a fresh rider and they reached the climb with half the reserve gone. Setting that ceiling before the race, and adjusting it for what will have happened before the climb, is the coach’s job.

What has to be decided?

A maximum power for each climb, not one average for the whole event. To set it you need two numbers for the rider: critical power (CP), what they can hold for a long time, and W′, the finite reserve they spend every time they ride above CP1. W′ is spent on every ramp and refills, slowly, when riding below CP2. The balance of that reserve over the course, W′bal, is what tells you how much is left at the foot of each climb.

An example: the 8-minute climb

A rider with a 300 W CP and a 20 kJ W′ faces an 8-minute climb near the end of a time trial. The coach wants them to crest with about 4 kJ left, so they do not reach the flat finish empty:

  • If they arrive fresh, with all 20 kJ, the ceiling is 333 W.
  • If they arrive with 12 kJ, because they spent it on earlier rises and had no time to recover, the ceiling drops to 317 W.
  • If they start at 360 W, the number they hit on their best days, the reserve is gone after 5 min 33 s and they face two and a half minutes of climbing below CP.
360 W, fresh333 W, fresh317 W, with 12 kJ
0510152002468Climbing time (min)W′ remaining (kJ)5:33
Figure 1. W′ reserve over the example climb. The right ceiling is not the same if the rider arrives fresh or with the reserve already spent. Calculated with the critical power model.
The key point. A climb’s ceiling depends on what came before it. That is why a single number for every climb in the event is almost always wrong for one of them.

What changes in the training plan?

  • Measure CP and W′, not just FTP: two or three maximal efforts of different durations estimate both. Without W′ there is no way to set a ceiling.
  • Update them with fitness: CP and W′ change with each training block. A ceiling based on three-month-old data can be too high or too cautious.
  • Fit recovery to the rider: in high-level cyclists, W′ refills faster than the original model predicts4. If your rider is one of them, the ceiling on climbs that follow a descent can be a little higher.
  • Rehearse the climb: a session that reproduces what comes before (rises, fast flat) and ends with the climb at the ceiling. If they make it to the top with legs left, the ceiling is right.

How do you take it into the race?

  1. One written ceiling per climb: “Climb 2: do not exceed 333”. A ceiling works better than a target, because the usual mistake is going over in the first minutes.
  2. The first 90 seconds: that is where the reserve disappears without the rider noticing. They should check the number as they hit the ramp, not halfway up.
  3. The reserve on screen: if the head unit shows W′bal, the rider sees how much is left, not only how hard they are pushing.
  4. Review afterwards: the model describes racing well when CP and W′ are measured properly3. If the rider blew up with plenty of theoretical reserve, the problem is in the data, not the rider.

Frequently asked questions

Is the ceiling the same as the climb’s power target?

No. The target is what is worth riding to gain time; the ceiling is what must not be exceeded to avoid blowing up. On long climbs they tend to be close; on short ramps the target can be above CP and the ceiling marks how far.

Does the ceiling change from one climb to the next?

Yes: it depends on the reserve the rider brings to each one, so the second climb usually has a lower ceiling than the first. How that fits the split of the whole event is in how much to vary power in a hilly time trial.

In a SuperRecord plan, the W′bal trace sits next to the power split so you can see how much reserve the rider has at the foot of each climb. The section-by-section split is in the demo on the Tour time trial.

References

  1. Jones AM, Vanhatalo A. The ‘Critical Power’ concept: applications to sports performance with a focus on intermittent high-intensity exercise. Sports Med. 2017;47(Suppl 1):65-78. doi:10.1007/s40279-017-0688-0
  2. Skiba PF, Chidnok W, Vanhatalo A, Jones AM. Modeling the expenditure and reconstitution of work capacity above critical power. Med Sci Sports Exerc. 2012;44(8):1526-32. doi:10.1249/MSS.0b013e3182517a80
  3. Skiba PF, Clarke D, Vanhatalo A, Jones AM. Validation of a novel intermittent W′ model for cycling using field data. Int J Sports Physiol Perform. 2014;9(6):900-4. doi:10.1123/ijspp.2013-0471
  4. Bartram JC, Thewlis D, Martin DT, Norton KI. Accuracy of W′ recovery kinetics in high performance cyclists: modeling intermittent work capacity. Int J Sports Physiol Perform. 2018;13(6):724-8. doi:10.1123/ijspp.2017-0034

Related articles