← Back to the blog

Garmin Edge data screen for time trials and triathlon: which fields to show and which to drop

Time trial6 min readBorja Alfaraz

Time trial screen

19 km/h

How much a rider’s speed changes at the same 300 W between a 15 km/h headwind (34 km/h) and a 15 km/h tailwind (53 km/h).

Model calculation: CdA 0.24 m², 78 kg with the bike, flat. That is why speed is no use for pacing the effort.

A Garmin Edge data screen for a time trial needs few, well-chosen fields: a slightly smoothed power figure in large type, the section target if there is a plan, the section’s average power, time and distance to go. Everything else is a distraction. Speed, which is the first thing many people look at, is no use for pacing: at the same power it can change by 19 km/h depending on the wind. For triathlon the base is the same, with an extra field or two to keep a long event’s spending under control.

Summary. Speed depends on wind and gradient as much as on power, as any validated model shows1. Power is the direct measure of effort, with its own measurement limits2,3. In practice, riders tolerate moderate power variation4, and in an Ironman power changes a lot with terrain and wind5: the screen has to help keep that variation under control.

Which fields go on a time trial screen?

Every field in the table exists on the Edge according to its official manual, except the section target, which depends on the data field that carries the plan.

FieldWhat forTime trialTriathlon
3 s or 10 s powerCurrent effort, without the jitter of instantaneous powerYes, largeYes, large
Section targetWhat power is due on each part of the courseYes, with a planYes, with a plan
Lap powerAverage of the current section, with laps by distance or positionYesYes
TimeGeneral referenceYesYes
Distance to destinationHow far is left; needs the course to be navigatedYesYes
Normalized power or kilojoulesTrack total spending in a long eventNot neededOn a second screen
Heart rateContext, not a pacing guideSmall or offSmall
SpeedDepends on wind and gradientOffOff

Table 1. Fields for a time trial or triathlon bike screen on the Garmin Edge.

Why not watch speed?

Because it misleads both ways. At 300 W, the rider in the example does 43 km/h with no wind, 34 km/h into a 15 km/h headwind and 53 km/h with the same wind behind. Gradient does the same: a 2 % rise drops them to 34 km/h and a 2 % descent lifts them to 53 km/h. If the rider tries to hold a speed, they overdo the watts into the wind and underdo them with it behind, exactly the opposite of what pays (we explain it in out-and-back time trial in the wind).

3-second or 10-second power?

Instantaneous power jumps too much to read at 45 km/h, because it reflects every pedal stroke and every bump. Three-second power responds quickly and suits courses with many changes; ten-second power is steadier and easier to read on long flat stretches. Many riders show one in large type with the section’s average power next to it, which is what tells them whether the section is going well. What does not pay is chasing the number every second: power meters also have a margin of error, which varies between models2,3.

Coach’s rule. One large number to pace by, one to know whether the section is going well and one to know how far is left. If the rider needs more than five fields to race a time trial, the plan is too complicated.

Which fields look useful but are not?

  • Percentage of FTP: it depends on the FTP on the Edge being current. If it is not, the rider chases a percentage of a number that is no longer theirs. Better the target watts, with no middleman.
  • Power zone: each zone spans many watts. For a time trial, where the gap between riding well and overdoing it is a few watts, it is too coarse.
  • Heart rate as a guide: it is slow to respond to changes in effort and rises with heat and fatigue even when power does not change. It is context, not a way to pace a time trial.
  • Too many screens: every screen change is a moment not looking at the road or the target. One race screen and, at most, one spare.

Which Edge settings are worth checking?

  • Auto Lap: the manual lets you mark laps by distance or by position. If they match the plan’s sections, lap power becomes section power.
  • Auto Pause: according to the manual, history is not recorded while the timer is paused. In a race it is worth turning it off, so that a slow corner does not leave gaps in the file that later spoil the analysis.
  • Auto Scroll: it cycles through the screens on its own. In a time trial a fixed screen is better.
  • A dedicated activity profile: screens are set per profile. A separate time-trial profile avoids changing the training screens.

What changes on a triathlon screen?

In an Ironman, power changes a lot over the bike leg with terrain and wind5, and the classic mistake is going too hard in the first hour. So the large power field is joined by a second screen with normalized power or accumulated kilojoules, so the triathlete can see whether spending is on track. But the first screen must stay just as simple. How much power variation is reasonable is covered in the variability index in time trials and triathlon.

How does the plan get onto the screen?

The Edge’s standard fields show what the rider is doing, not what is due. The Edge’s “time ahead” field refers to the Virtual Partner, according to the manual, not to a section plan. For the screen to show each section’s target and the gap to the forecast time, you need a data field that carries the plan. That is what SuperRecord Pacer does, explained in how to carry your power plan on your Garmin. Garmin’s own alternative is reviewed in Garmin Power Guide in a time trial.

Whatever the field, rehearse the screen beforehand: in a session at race pace, with the plan loaded, the rider checks they can read the numbers at race speed and that target changes arrive where they should. The power variations the plan asks for have to be acceptable to the rider4, and the screen is where you find out whether they are.

Frequently asked questions

How many fields on a time trial screen?

Four to six: 3 or 10-second power, section target, lap power, time and distance to go. Heart rate small, if at all.

Does it work on an Edge 130 Plus?

Yes, with less space. The SuperRecord Pacer field works on the 130 Plus with plans of up to 30 blocks.

What about a Wahoo?

The logic of the fields is the same. The plan can be carried as a .FIT file with a power target per section.

References

  1. Martin JC, Milliken DL, Cobb JE, McFadden KL, Coggan AR. Validation of a mathematical model for road cycling power. J Appl Biomech. 1998;14(3):276-91. doi:10.1123/jab.14.3.276
  2. Passfield L, Hopker JG, Jobson S, Friel D, Zabala M. Knowledge is power: issues of measuring training and performance in cycling. J Sports Sci. 2017;35(14):1426-34. doi:10.1080/02640414.2016.1215504
  3. Maier T, Schmid L, Müller B, Steiner T, Wehrlin JP. Accuracy of cycling power meters against a mathematical model of treadmill cycling. Int J Sports Med. 2017;38(6):456-61. doi:10.1055/s-0043-102945
  4. Atkinson G, Peacock O, Law M. Acceptability of power variation during a simulated hilly time trial. Int J Sports Med. 2007;28(2):157-63. doi:10.1055/s-2006-924209
  5. Abbiss CR, Quod MJ, Martin DT, Netto KJ, Nosaka K, Lee H, et al. Dynamic pacing strategies during the cycle phase of an Ironman triathlon. Med Sci Sports Exerc. 2006;38(4):726-34. doi:10.1249/01.mss.0000210202.33070.55

Related articles