← Back to the blog

Flying 200 m: how it is ridden, which gear to use and reference times

Track6 min readBorja Alfaraz

Flying 200 m

8.857 s

Flying 200 m world record, set by Matthew Richardson on 15 August 2025 in Konya (Turkey). An average of 81.3 km/h.

Official UCI record list, updated 10 February 2026. The women's record is 9.759 s, by Emma Finucane.

Summary. The flying 200 m is the shortest event in track cycling: about 10 or 11 seconds at top speed1. The result depends on the maximum power the sprinter can produce relative to their frontal area and on the cadence at which they produce it2, and models of power and resistance allow each factor to be studied3,4. This article explains how it is ridden, which gear and cadence to choose and what the official reference times are.

The flying 200 m is ridden by entering the final 200 metres already at full speed, after a few build-up laps in which the rider climbs the banking and dives down to gain speed. Only that final stretch is timed. The men's world record is 8.857 seconds and the women's 9.759, according to the UCI. For a club rider, going under 11 seconds already means more than 65 km/h.

How is a flying 200 m ridden?

It is the qualifying round for the individual sprint. The rider starts, does build-up laps riding up towards the top of the banking and, on the last one, dives down to cross the 200 m line as fast as possible. From there, four fifths of a lap on a 250 m track, the job is to lose as little speed as possible to the finish.

Three decisions shape the time. When to start accelerating, because starting too early means reaching the line already fading. How high to dive from, which adds free speed. And which line to take through the final bend, because every metre outside the measurement line is extra distance.

What are the reference times?

The only official and verifiable references are UCI records. National federations also publish their own records by category, but there is no official table of "good times" by level.

CategoryRecordAverage speedRider, date and venue
Elite men8.857 s81.3 km/hMatthew Richardson, 15-8-2025, Konya
Elite women9.759 s73.8 km/hEmma Finucane, 2-2-2026, Konya
Junior men9.738 s73.9 km/hStefan Ritter, 7-10-2016, Aguascalientes
Junior women10.508 s68.5 km/hStefany Cuadrado Flórez, 9-8-2024, Saint-Quentin-en-Yvelines

Table 1. Flying 200 m world records according to the official UCI lists, checked on 4 November 2026 (elite men updated 10-2-2026, elite women 28-7-2026, junior men 18-7-2025 and junior women 31-8-2026). Average speed is distance over time.

The junior men's record was set in Aguascalientes (Mexico), an indoor track at altitude, where thinner air slows riders less. When comparing your rider's times, always compare on the same track or account for the air (we explain it in air density and speed).

Which gear and cadence should you use?

In world-class sprinters, the cadence at which they produce maximum power is around 130 rpm, but in the 200 m they pedal considerably faster: 155 rpm on average in international events and 149 in a national championship2. In other words, they race above their optimal cadence, and those with a higher optimal cadence are better placed to make use of their power2.

TimeSpeedAt 140 rpmAt 150 rpmAt 160 rpmPower on the flat
10.0 s72.0 km/h8.57 m8.00 m7.50 m1249 W
10.5 s68.6 km/h8.16 m7.62 m7.14 m1082 W
11.0 s65.5 km/h7.79 m7.27 m6.82 m945 W
11.5 s62.6 km/h7.45 m6.96 m6.52 m830 W
12.0 s60.0 km/h7.14 m6.67 m6.25 m733 W

Table 2. Average speed, metres of development per pedal revolution at each cadence, and power to hold that speed on the flat. Model example for power: 90 kg for rider and bike, CdA 0.25 m², Crr 0.0022, air density 1.18 kg/m³; it excludes the previous acceleration and the boost from diving off the banking, which reduce what must be produced in the timed stretch itself.

The table turns a target into a gear. If your rider is aiming for 11 seconds and their good flying cadence is 150 rpm, they need about 7.3 metres per revolution. With the flying 200 m calculator you pick chainring, cog and tyre and it gives you the exact cadence; the track gear calculator shows every combination.

Rule of thumb. Choose the gear so that, at target speed, cadence sits in the high zone where your rider still produces a lot of power. Too big and they never fully wind it up; too small and they run out of leg speed before the line.

What determines the time?

  • Maximum power: around 1600 W2 and almost 1800 W3 have been measured in elite sprinters, with very similar values in the lab and on the track3.
  • Power relative to frontal area: this was what best related to speed over the 200 m2. At these speeds, air is the dominant resistance.
  • Optimal cadence: the closer it is to the event's real cadence, the better2.
  • The build-up: height, timing of the jump and line. Sprint models make it possible to study each decision separately4.

How is it trained and planned?

From a coach's point of view, there are three levers: raising maximum power, lowering CdA in the sprint position and choosing the gear and build-up well. The last two can improve within weeks. Measuring CdA on the track has its own quirks, explained in the AthletePro article on track CdA. SuperRecord plans the flying 200 m with the rider's CdA, power and the air on the day; you can see how it works in the demo. If your rider also does the kilo, see the track kilometre time trial.

What is known and what is not

The physical factors that explain flying 200 m performance are well described1,2, and lab-measured power can be used to model track performance3. What the literature does not provide are reference times by category and level from large samples; for that, use official records and your rider's own history on their home track.

Frequently asked questions

What is the flying 200 m world record?

8.857 seconds for men (Matthew Richardson, 2025) and 9.759 for women (Emma Finucane, 2026), according to the UCI.

What is a good flying 200 m time?

There is no official table by level. As a physical guide, 11 seconds is 65.5 km/h and 12 seconds is 60 km/h. Junior records are under 10 seconds for men and under 10.6 for women.

What cadence is used in the flying 200 m?

In world-class sprinters, about 150 to 155 rpm on average, above the cadence at which they produce maximum power.

What gear do I need for 11 seconds?

At 150 rpm, about 7.3 metres per revolution; at 140 rpm, about 7.8. The calculator gives you the chainring and cog combination.

References

  1. Craig NP, Norton KI. Characteristics of track cycling. Sports Med. 2001;31(7):457-68. doi:10.2165/00007256-200131070-00001
  2. Dorel S, Hautier CA, Rambaud O, Rouffet D, Van Praagh E, Lacour JR, et al. Torque and power-velocity relationships in cycling: relevance to track sprint performance in world-class cyclists. Int J Sports Med. 2005;26(9):739-46. doi:10.1055/s-2004-830493
  3. Gardner AS, Martin JC, Martin DT, Barras M, Jenkins DG. Maximal torque- and power-pedaling rate relationships for elite sprint cyclists in laboratory and field tests. Eur J Appl Physiol. 2007;101(3):287-92. doi:10.1007/s00421-007-0498-4
  4. Martin JC, Davidson CJ, Pardyjak ER. Understanding sprint-cycling performance: the integration of muscle power, resistance, and modeling. Int J Sports Physiol Perform. 2007;2(1):5-21. doi:10.1123/ijspp.2.1.5

Related articles